Tuesday, 10 June 2014

deal with the two most common kinds of floorboards without creating havoc


Homeowners who have installed Floorboards in their home should learn to properly lift and repair it to avoid additional maintenance cost in the future. Sometimes, we need to lift it to inspect malfunctioning water pipers below or fix and replace a creaking board, which has been warped and split with wear. An important reminder is to avoid nailing or screwing down a loose board or sawing it before you check on what is beneath it. To avoid damaging floorboards, use a cable detector or an electronic pipe first to try and search for any underfloor cables and pipes. Having a miniature pool inside your house is not what you are aiming for.

Repairing floorboards can be quite tedious especially if it’s covered by a carpet. Here’s how to deal with the two most common kinds of floorboard without creating havoc, dust and damp.

Square-edged floorboards

These are the easiest type of board to lift. Start by pushing a 25 mm wide blade chisel into the joint between the boards, near to one end. The chisel will only cause minimal damage to the adjacent board as it spread the load. Push down the chisel handle to force the board upward. Repeat this process on the other side until everything has been raised high enough for the claw of the hammer to be inserted.
Use the claw to pull the nails from its joists. When you have pulled most of it, you can now lift the board easily. To remove a stable floorboard underneath the board at the end of the room, you will need to take out the skirting board first. Applying another option, sawing the center of the board could be dangerous if you are unaware of what is underneath.

Tongue-and-groove boards


Tongue and groove Flooring interwoven boards are more unbending so it is less likely to creak or move. This however means it is heavy and tougher to lift. You need to look for your pipes and cables first, and then use a wide bladed wood mallet and chisel or a well-designed floorboard cutter or saw, to cut through the tongues under. This method allows a cut to start at the floorboard gaps and directly into the tongue.

Top tip

When you plan on lifting a floorboard, try to slot tiny planks of timber into the newly made gap between the joist and the board. This helps you fidget the board out easily. Then, when inserting the hammer’s claw to knob the floorboard higher, you must protect the adjacent board from being dented by the hammer, by thrusting a thin offcut of wood underneath the head of the hammer.

There you go, dealing with floorboards both maintenance and repair should be done properly to avoid additional cost in the future, once you get to understand the proper techniques, everything will be a walk in the park and will leave you with no worries. For a long lasting and hassle-free flooring, follow these simple guidelines and you will have a durable and high quality floor for a long time.