Homeowners
who have installed Floorboards
in their home should learn to properly lift and repair it to avoid
additional maintenance cost in the future. Sometimes, we need to lift
it to inspect malfunctioning water pipers below or fix and replace a
creaking board, which has been warped and split with wear. An
important reminder is to avoid nailing or screwing down a loose board
or sawing it before you check on what is beneath it. To avoid
damaging floorboards, use a cable detector or an electronic pipe
first to try and search for any underfloor cables and pipes. Having a
miniature pool inside your house is not what you are aiming for.
Repairing
floorboards can be quite tedious especially if it’s covered by a
carpet. Here’s how to deal with the two most common kinds of
floorboard without creating havoc, dust and damp.
Square-edged
floorboards
These
are the easiest type of board to lift. Start by pushing a 25 mm wide
blade chisel into the joint between the boards, near to one end. The
chisel will only cause minimal damage to the adjacent board as it
spread the load. Push down the chisel handle to force the board
upward. Repeat this process on the other side until everything has
been raised high enough for the claw of the hammer to be inserted.
Use
the claw to pull the nails from its joists. When you have pulled most
of it, you can now lift the board easily. To remove a stable
floorboard underneath the board at the end of the room, you will need
to take out the skirting board first. Applying another option, sawing
the center of the board could be dangerous if you are unaware of what
is underneath.
Tongue-and-groove
boards
Tongue and groove Flooring
interwoven boards are more unbending so it is less likely to creak or
move. This however means it is heavy and tougher to lift. You need
to look for your pipes and cables first, and then use a wide bladed
wood mallet and chisel or a well-designed floorboard cutter or saw,
to cut through the tongues under. This method allows a cut to start
at the floorboard gaps and directly into the tongue.
Top
tip
When
you plan on lifting a floorboard, try to slot tiny planks of timber
into the newly made gap between the joist and the board. This helps
you fidget the board out easily. Then, when inserting the hammer’s
claw to knob the floorboard higher, you must protect the adjacent
board from being dented by the hammer, by thrusting a thin offcut of
wood underneath the head of the hammer.
There
you go, dealing with floorboards both maintenance and repair should
be done properly to avoid additional cost in the future, once you get
to understand the proper techniques, everything will be a walk in the
park and will leave you with no worries. For a long lasting and
hassle-free flooring, follow these simple guidelines and you will
have a durable and high quality floor for a long time.

